Previous Article | Next Article ![]()
Applied and Environmental Microbiology, September 2005, p. 5399-5403, Vol. 71, No. 9
0099-2240/05/$08.00+0 doi:10.1128/AEM.71.9.5399-5403.2005
Copyright © 2005, American Society for Microbiology. All Rights Reserved.
Center for Indoor Air Research, Department of Microbiology and Immunology, Health Sciences Center, Texas Tech University, Lubbock, Texas 79430
Received 28 October 2004/ Accepted 28 March 2005
|
|
|---|
|
|
|---|
|
|
|---|
Organisms.
Four fungal species, Penicillium chrysogenum (ATCC 9179), Chaetomium globosum (ATCC 16021), a nontoxic strain of Stachybotrys chartarum (ATCC 9633), a toxic strain of Stachybotrys chartarum, and Cladosporium cladosporioides were used. C. cladosporioides and the toxic strain of S. chartarum were collected from building materials and identified in the Center for Indoor Air Research Texas Tech University Health Science Center using reference texts (4, 17). Toxicity of the environmental isolate of S. chartarum was determined by a yeast toxicity assay (5). All organisms were identified and verified using reference texts (4, 17).
Fungal colony preparation.
For each species, conidia were collected from mature cultures on PDA and suspended in PBS. The concentration of conidia was determined by averaging at least four counts on hemocytometer and multiplying the dilution factor.
A total of 1 x 105 conidia were then inoculated onto a 2- by 2-cm sterile Whatman no. 3 filter paper that had been placed in the center of 35- by 10-mm PDA medium plates. The plates were sealed and then incubated at 25°C and 40 to 60% relative humidity until fungal colonies were both sporulating and established over the filter papers.
Ascospore preparation.
For ascospore collection, only PDA plates with mature colonies were used. It was ascertained microscopically that the majority of the perithecia had erupted, freeing the ascospores. Following that, 10 to 15 ml of PBS was added to the plate and a sterile glass rod was used to gently remove the spores from the colonies. The spore suspension was then centrifuged and the pellets of the spores were resuspended to have a concentration of 200,000 spores per microliter. The spore concentration of suspension was determined as described above. No parts of perithecia or hyphae were seen microscopically in the spore suspension. A total of 2 x 106 conidia were then inoculated onto a 2- by 2-cm sterile Whatman filter paper that had been placed in the center of a 35- by 10-mm plate and dried inside a biohazard cabinet.
Chlorine dioxide treatment.
Each gas treatment consisted of three separate runs with five replicates of each fungal species per run. The filter papers with fungal colonies were then placed separately on Petri dish lids inside a 20.8-liter gas chamber which was created by modifying a commercially available pressure cooker. Chlorine dioxide gas at either 500 ppm or 1,000 ppm was created according to the instructions of the manufacturer in the gas chamber through the use of 6 g Aseptrol S10-Tab tablets (Engelhard Corporation, Iselin, New Jersey) dissolved in distilled water. The gas chamber was then sealed for 24 h at room temperature under a fume hood. Control samples, that is, filter papers with identical fungal growth on them were placed in an identical gas chamber without ClO2 gas. As an additional check on the production of ClO2 gas in the chambers, one day old Escherichia coli cultures (ATCC DH5-
) on sheep blood agar plates provided by Clinical Microbiology Department of Texas Tech University Health Sciences Center (Becton Dickinson and Company, Sparks, MD) were placed inside the test and control gas chambers at room temperature. After the treatments, the E. coli colonies were streaked on to blood agar plates and checked for the next 2 days for bacterial growth at 37°C. This organism has been shown to be sensitive to low ClO2 gas concentrations (8). The actual measurement of the concentration of ClO2 gas was conducted as a separate run of experiments.
CFU determination.
After treatment, the filter papers with fungal colonies were removed from the gas chamber and placed into a 10-ml sterile tube containing 5 ml of PBS. After 3 h of occasional vortexing, the suspension was diluted up to four times in 10-fold serial dilutions. For each of five replicates, a total of 100 µl of each dilution was spread plated on PDA media in 150- by 10-mm petri dishes. The plates were sealed and then incubated at 25°C for 5 to 7 days at which time they were examined for fungal growth, which was recorded as CFU. A treatment efficiency (TE) value was calculated for comparison purposes between test and controls. The value was derived by subtracting the recovered test CFU (T) from the recovered control CFU (C) and expressing the difference as a percentage, e.g., %TE = [(CT)/C)]x100.
During the first step of CFU determination, an aliquot was removed from the suspension and placed in a hemocytometer where the fungal conidia were counted. Total conidia numbers were then compared to the number of recovered CFU for tests and control. The ratio of recovered CFU to total conidia was also determined, resulting in a percent culturable spores value.
Toxicity determination.
Kluyveromyces marxianus (ATCC 8554), a yeast demonstrated to be particularly sensitive to trichothecene mycotoxins (5), was maintained in YPG-50 (1% yeast extract, 1% bacteriological peptone, and 50 mM glucose) (5) at 80°C in a 1-ml aliquot. Cultures for inoculation of the bioassay were prepared by adding 1 ml aliqout to 50 ml of YPG-50 in a culture flask. The flask was incubated in a rotary incubator for approximately 16 h at 37°C. For the bioassay procedure, YPG-50 was supplemented from a stock solution of polymixin B sulfate (PMBS; ICN Biomedicals, Seoul, Korea) to give a final bioassay PMBS concentration of 15 mg/ml (5). A total of 136 µl of PMBS supplemented YPG-50 medium was added to the wells of a 96-well polystyrene microtiter plate in triplicate. A total of 8 µl of test sample or control was added to each well, followed by 16 µl of yeast inoculum to yield an initial cell density of approximately 1 x 108 cells/ml. Blank wells contained 152 µl of medium and 8 µl of sterile distilled water. Negative control wells consisted of 144 µl of medium and 16 µl of yeast inoculum. Positive control wells were also included which contained the medium, yeast inoculum and one microgram of roridin A. The plates were sealed and incubated on a plate shaker at 37°C for 8 h. Turbidity was measured every two hours by measuring the absorbance at 550 nm in a microtiter plate reader. Toxicity of the sample was based on these absorbances. Yeast growth resulted in high absorbance, indicating that the sample was not toxic. Conversely, the lower the absorbance, the more toxic the sample was to the yeast.
Statistical analysis.
To determine if the treatments may have destroyed conidia rather than compromised them, the mean number of C. globosum ascospores for the two test treatments were compared to the control mean (N = 30 control and 15 test). This analysis was not performed on the hyphomycetes organisms because the pre-treatment conidia numbers could not be determined and an analysis on the final numbers therefore could not be made. A one-way analysis of variance (ANOVA) was performed on the ascospore test and control means followed by a Tukey's post hoc test (SigmaStat software, version 2.0; SPSS Inc., Chicago, IL). Conditions of normality and equal variance were met for the analysis.
|
|
|---|
|
View this table: [in a new window] |
TABLE 1. Means and standard errors for results of a trial that examined the efficacy of CLO2 gas over 24 h on the culturability and overall conidia numbers of three hyphomycetes mold species
|
|
View this table: [in a new window] |
TABLE 2. Means and standard errors for results of a trial that examined the efficacy of ClO2 gas over 24 h on the culturability and overall conidia numbers of the ascomycete C. globosum
|
![]() View larger version (13K): [in a new window] |
FIG. 1. Graph showing the representative result from a trial that examined the efficacy of ClO2 gas over 24 h on the toxicity of S. chartarum (Stachy) colonies using a yeast toxicity assay. High absorbance readings indicate nontoxicity. NT, nontoxic strain; Tox, toxic strain.
|
|
View this table: [in a new window] |
TABLE 3. Means and standard errors for results from a yeast toxicity assay showing mean optical densities at a wavelength of 550 nm taken at 8 h of incubation for toxic and nontoxic Stachybotrys chartarum compared to positive and negative controls
|
|
|
|---|
It is not clear if the nonculturable spores themselves will be a health hazard in the same way that culturable spores are. However, nonculturable spores will prevent further growth of colonies and inhibition of fungal growth will prevent further mycotoxin production.
In this experiment, filter paper is used to represent the actual building materials in terms of food source and physical support. Further research is needed to show the effectiveness of the treatment of mold damaged buildings with high concentration ClO2 gas.
Chaetomium globosum (Chaetomiaceae, Sordariales, Sordariomycetidae, Ascomycetes) is an ascomycete that produces conidia known as ascospores which are characterized by a thick multilayered spore coat. Numerous ascospores are situated within an ascus which is a sac-like structure. The asci in turn are situated inside another enclosure called perithecia (11). Nothing is known of the function of the ascus and the perithecia with relation to fungicidal agents. The results of this trial indicate that these two additional layers played a slightly protective role for the Chaetomium ascospores against the oxidative effect of ClO2. This may possibly be due to the ascus and perithecia providing a physical protective barrier against the gas. The treatment of C. globosum with ClO2 at 500 ppm resulted in a TE of 91%, while the 1,000 ppm treatment resulted in a TE of 87%. This indicates that a ClO2 concentration of 500 ppm is high enough to inhibit fungal growth.
The treatment was not successful in detoxifying the nonculturable toxic strain of S. chartarum. Chlorine was chosen as the active agent in this study because previous studies have shown that sodium hypochlorite can inactivate trichothecene mycotoxins (18). It has also been effective in inactivating aflatoxins (19). We have also shown that ClO2 is effective against the trichothecene mycotoxins roridin A and verrucarin A placed in water (data not shown). Satratoxin G is the main trichothecene mycotoxin produced by. S. chartarum and it is found predominantly on S. chartarum conidia, both on the outer membrane and the inner layer of the conidia (7) and it is possible that because of their location the gas was not able to inactivate the trichothecenes.
While the gas treatment is successful in inactivating mold and bacterial colonies, the treatment comes with a caveat in that chlorine dioxide gas has corrosive properties and care has to be taken that the treatment does not result in the degradation of the contents as well as the components of the structure. It has been used in the past, as the disinfection of the offices of the Hart Senate Office Building by the Environmental Protection Agency in 2002 was achieved with the help of ClO2 gas. This treatment can be considered where buildings are emptied of sensitive items and the construction of the building is such that there are inaccessible mold contaminated areas.
In conclusion, this study has shown that chlorine dioxide gas can be effective to a degree as a fumigant for the inactivation of certain fungal colonies, that the perithecia/asci of C. globosum can play a protective role for the ascospores and that S. chartarum, while inactivated by the fumigation treatment, still remains toxic at the tested dosages.
S. C. Wilson and D. C. Straus were supported by a Center of Excellence grant from TTUHSC. D. C. Straus and T. L. Brasel were supported by a grant from the Texas Higher Education Coordinating Board.
|
|
|---|
This article has been cited by other articles:
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Copyright © 2009 by the American Society for Microbiology. For an alternate route to Journals.ASM.org, visit: http://intl-journals.asm.org | More Info»