This Article
Right arrow Full Text
Right arrow Full Text (PDF)
Right arrow Alert me when this article is cited
Right arrow Alert me if a correction is posted
Services
Right arrow Similar articles in this journal
Right arrow Similar articles in PubMed
Right arrow Alert me to new issues of the journal
Right arrow Download to citation manager
Right arrowReprints and Permissions
Right arrow Copyright Information
Right arrow Books from ASM Press
Right arrow MicrobeWorld
Citing Articles
Right arrow Citing Articles via Google Scholar
Google Scholar
Right arrow Articles by Paramonova, E.
Right arrow Articles by Logan, B. E.
Right arrow Search for Related Content
PubMed
Right arrow PubMed Citation
Right arrow Articles by Paramonova, E.
Right arrow Articles by Logan, B. E.
Agricola
Right arrow Articles by Paramonova, E.
Right arrow Articles by Logan, B. E.

 Previous Article  |  Next Article 

Applied and Environmental Microbiology, August 2006, p. 5190-5196, Vol. 72, No. 8
0099-2240/06/$08.00+0     doi:10.1128/AEM.02988-05
Copyright © 2006, American Society for Microbiology. All Rights Reserved.

Measurement of Biocolloid Collision Efficiencies for Granular Activated Carbon by Use of a Two-Layer Filtration Model

Ekaterina Paramonova, Erica L. Zerfoss, and Bruce E. Logan*

Department of Civil and Environmental Engineering, The Penn State Hydrogen Energy (H2E) Center, The Pennsylvania State University, University Park, Pennsylvania 16802

Received 19 December 2005/ Accepted 18 May 2006

Point-of-use filters containing granular activated carbon (GAC) are an effective method for removing certain chemicals from water, but their ability to remove bacteria and viruses has been relatively untested. Collision efficiencies ({alpha}) were determined using clean-bed filtration theory for two bacteria (Raoutella terrigena 33257 and Escherichia coli 25922), a bacteriophage (MS2), and latex microspheres for four GAC samples. These GAC samples had particle size distributions that were bimodal, but only a single particle diameter can be used in the filtration equation. Therefore, consistent with previous reports, we used a particle diameter based on the smallest diameter of the particles (derived from the projected areas of 10% of the smallest particles). The bacterial collision efficiencies calculated using the filtration model were high (0.8 ≤ {alpha} ≤ 4.9), indicating that GAC was an effective capture material. Collision efficiencies greater than unity reflect an underestimation of the collision frequency, likely as a result of particle roughness and wide GAC size distributions. The collision efficiencies for microspheres (0.7 ≤ {alpha} ≤ 3.5) were similar to those obtained for bacteria, suggesting that the microspheres were a reasonable surrogate for the bacteria. The bacteriophage collision efficiencies ranged from ≥0.2 to ≤0.4. The predicted levels of removal for 1-cm-thick carbon beds ranged from 0.8 to 3 log for the bacteria and from 0.3 to 1.0 log for the phage. These tests demonstrated that GAC can be an effective material for removal of bacteria and phage and that GAC particle size is a more important factor than relative stickiness for effective particle removal.

* Corresponding author. Mailing address: Department of Civil and Environmental Engineering, The Penn State Hydrogen Energy (H2E) Center, The Pennsylvania State University, University Park, PA 16802. Phone: (814) 863-7908. Fax: (814) 863-7304. E-mail: blogan{at}psu.edu.

Applied and Environmental Microbiology, August 2006, p. 5190-5196, Vol. 72, No. 8
0099-2240/06/$08.00+0     doi:10.1128/AEM.02988-05
Copyright © 2006, American Society for Microbiology. All Rights Reserved.





Copyright © 2009 by the American Society for Microbiology.   For an alternate route to Journals.ASM.org, visit: http://intl-journals.asm.org | More Info»